Pack 12 LED rossi 1206 alta luminosità per cellulari e dispositivi elettronici

Cada LED SMD 1206 té unes dimensions aproximades de 3.2 mm x 1.6 mm x 1.1 mm (llarg x ample x alt). El pes d'un LED individual és típicament inferior a 0.05 grams, de manera que el pack complet de 12 peces pesa menys d'1 gram en total.

Es recomana utilitzar un soldador de punta fina entre 320–350°C amb un temps de contacte breu (<3 segons per pin) per evitar danys per calor. El component és sensible a descàrregues electrostàtiques: és aconsellable fer servir una polsera antiestàtica. Assegureu-vos de respectar la polaritat i de no superar la corrent i la tensió especificades.

En condicions estàndard (20 mA, ambient <50°C), la vida útil esperada és de 30.000 a 50.000 hores abans que la brillantor es redueixi al 70% de l’original. La durabilitat disminueix si se supera la corrent màxima, s’aplica excés de temperatura durant la soldadura o si hi ha humitat elevada sostinguda. Els LEDs SMD no són resistents a impactes mecànics severs.

It is recommended to use a fine-tipped soldering iron at 320–350°C with brief contact time (<3 seconds per pin) to avoid heat damage. The component is sensitive to electrostatic discharge, so using an anti-static wrist strap is advisable. Make sure to observe polarity and not exceed the specified current and voltage.

Under standard conditions (20 mA, ambient temperature below 50°C), the expected service life is 30,000 to 50,000 hours before brightness drops to 70% of the original level. Durability decreases if the maximum current is exceeded, excessive heat is applied during soldering, or there is sustained high humidity. SMD LEDs are not resistant to severe mechanical impact.

Each SMD 1206 LED measures approximately 3.2 mm x 1.6 mm x 1.1 mm (length x width x height). The weight of an individual LED is typically less than 0.05 grams, so the full pack of 12 pieces weighs less than 1 gram in total.

Each 1206 SMD LED measures approximately 3.2 mm x 1.6 mm x 1.1 mm (length x width x height). The weight of an individual LED is typically less than 0.05 grams, so the full pack of 12 pieces weighs less than 1 gram in total.

It is recommended to use a fine-tip soldering iron at 320–350°C with brief contact time (<3 seconds per pin) to avoid heat damage. The component is sensitive to electrostatic discharge, so using an anti-static wrist strap is advisable. Make sure to observe polarity and not exceed the specified current and voltage.

Under standard conditions (20 mA, ambient temperature below 50°C), the expected service life is 30,000 to 50,000 hours before brightness drops to 70% of the original level. Durability decreases if the maximum current is exceeded, excessive heat is applied during soldering, or there is sustained high humidity. SMD LEDs are not resistant to severe mechanical impact.

Det rekommenderas att använda en lödkolv med fin spets på 320–350°C och kort kontakttid (<3 sekunder per ben) för att undvika värmeskador. Komponenten är känslig för elektrostatisk urladdning, så det är lämpligt att använda antistatarmband. Se till att respektera polariteten och att inte överskrida angiven ström och spänning.